Open Power Release Notes

February 17th, 2021. Version V1.0.7718
  -- Updated the Release for new Toolbox version
  -- Dongle version updated to 59.13
  

May 11th, 2020. Version V1.0.7440

Enabled Rangeley device support.


March 05th, 2020. Version V1.0.7369

The USBXpress device driver has been upgraded to v6.7.2.0 and SiUSBXp.dll is upgraded to v6.7.5.(0)”


February 10th, 2020. Version V1.0.7345

This release contains the fixe for the below list of defects.
1. load file feature of .mic utiltity is not working (file corrupt error shows up when trying to review .mic files) - [JIRA_OPGUI-77]
2. [SugarloafR1 ATA] The ATA Design Tool crashes when Real Time Tuning is enabled and a parameter is changed. - [JIRA_OPGUI-71]
3. [SugarloafR1] Sugarloaf devices cannot be detected by Auto Populate or Scan Bus - [JIRA_OPGUI-72]
4. Sugarloaf; update config checker utility with attached file. added x+0 checkers...AMD 1 loop with errata items included, updated checked values for other configs - [JIRA_OPGUI-74]
5. Sugarloaf; add ICCMAX register to GUI - [JIRA_OPGUI-76]
6. Sugarloaf; update/add standard config files - [JIRA_OPGUI-79]
7. Sugarloaf; with FSW using 2^2 exponent, design tool requwncy is not correct. set freq to 1.7MHz, pid tool says freq = 2.8MHz... [JIRA_OPGUI-83]
8. DE Off-time Adjust Q Level is not correct for Pearson, Saddleback, and Sugarloaf - [JIRA_OPGUI-85]
9. wrong description in VOUT_COMMAND window - [JIRA_OPGUI-86]
10. Sugarloaf, add I2C threshold to regmap tree - [JIRA_OPGUI-87]
11. Sugarloaf, need to add D and H to the XDPE132G5 part number - [JIRA_OPGUI-89]
12. loading .mic function only shows 1 file..load .mic feature only shows 1 file no matter the number of .txt files in the .mic file - [JIRA_OPGUI-90]
13. PID calculation and Bode plot issues fix
14. Pearson - PMBus command 44 crash fix
15. Fix issue in Save Config File - Organization key was missing while reading the registry.
16. Sugarloaf; System Settings design tool shows wrong Switching Frequency for values above 1023.
17. Pearson, Saddleback; Incorrect decode on vaux_b1 and b2 register - [OPGUI-95]


July 23th, 2019. Version V1.0.7142

General
-- When trying to set a Numeric Up Down control value, the value is capped at the maximum & minimum. This should prevent errors when trying to load or set values outside the range.
-- Load Model
---- Made the Phase Margin, Gain Margin, and Crossover Frequency all absolute values.
-- Firmware version updated to v59

Sugarloaf
-- Utilities
---- Register Map
------ Added register "lvt_thresh_avs" under “Common ==> AVS ==> AVS Clock & Data Threshold”
---- Configuration Comparator
------ Added “AVS Clock & Data Threshold” to the list of registers to compare.